Skip to content
Shop
Explore

INDEPENDENT BMW ENGINE EXPERTISE

Problems with oil pressure. How to act?

N43 / N53 · NOXEM · DIAGNOSTICS

Select a technical image to view it in detail.

Oil pressure problems are common on N43 engines. They are very rare on N53 engines, but they do happen.

Symptoms of an oil pressure problem

  • A corresponding fault code, such as 30C1, is stored in the DME fault memory.
  • The PWM value of the oil pressure control valve (../F6/F2/F3) is low (<40%).

If the DME fault memory holds other codes, for example for the oil pressure sensor or the hydraulic pressure valve, start by checking the connections of those parts and replace them if necessary. Assume that has been done and the oil pressure is still low.

Emergency mode

In emergency mode the engine runs at maximum oil pressure (6..8 bar). Two cases occur:

  • On engines with a Bosch engine management system, typically no fault is stored in the DME.
  • On N43/N53 engines, fault 30C1 is stored and active.

In either case there is no doubt that the engine has a fundamental problem reaching the required oil pressure.

What to do

1. Replace the oil and the oil filter. This helps in at least half of cases. 2. Make sure the oil pressure sensor (../F6/F2/F2) reads correctly. Connect a manometer and compare its reading with the sensor’s reading. If the difference is more than 5..10%, replace the sensor. Compare the readings at different RPM and different required pressure values. If you don’t have a manometer, you can replace the sensor as a precaution. It costs only 30..50 EUR and quite often turns out to be the culprit. Sensor faults can also be sporadic, appearing and later disappearing, which makes them hard to identify. 3. Evaluate the oil pressure freeze frame:

  • Pressure problems on a cold engine: the typical cause is a clogged oil filter or oil catcher, or oil that is too thick or the wrong type.
  • Pressure problems right after starting the engine following a long standstill: the most likely cause is a damaged oil check valve, located in the bottom part of the oil filter housing.
  • Pressure problems on a hot engine: possible causes are increased oil flow through the bearing shells, increased oil pump wear, or a problem with the oil itself. The oil may lose viscosity, for example if it is diluted with fuel, or it may simply be the wrong oil.

If there is no clear pattern, the most common cause is the hydraulic oil pressure valve. It tends to clog with oil dirt and can also stick due to wear.

N43 oil pressure sensor

N43 hydraulic oil pressure valve

Part numbers of the N43 oil pressure sensor and hydraulic valve

Oil and filter quality

Use only premium-quality oil filters and oil that meets the specification, from a well-known brand. Buy them from reliable suppliers, and replace the oil and filter every 10,000 km.

If the basic repairs do not help

If the initial work did not help, namely:

  • replacing the oil and oil filter, and
  • replacing the oil pressure sensor and hydraulic pressure valve,

then unfortunately the cause lies deeper, and the engine should be entrusted to an experienced mechanic.

Possible causes:

  • A clogged oil catcher. It can clog with oil dirt, for example silicone residue used to seal the engine joints, or with debris from the chain tensioners.
  • Oil pump wear.
  • Increased flow through the oil circuit, typically due to worn bearing shells.

Note: after the oil pressure problem is fixed, the engine has to be re-adapted.

BEYOND THE FAULT CODE

A clearer picture.
A better next step.

Get in touch
Enlarged technical image
Open original image