Skip to content
Shop
Explore

INDEPENDENT BMW ENGINE EXPERTISE

What damages the NOx sensor

N43 / N53 · NOXEM · DIAGNOSTICS

Select a technical image to view it in detail.

In this entry I cover the root causes of premature NOx sensor failure and the ways to prolong the sensor’s life.

It applies to both the OEM sensor and the NOXEM. The NOXEM also uses an oxygen probe to measure the exhaust parameters. That probe is sturdier and longer-lived than the one in the OEM sensor, but it has its limits too.

Moisture and thermal stress

Water. Moisture from the air condenses in the exhaust, and water is also a by-product of the work of the CO catalytic converters. To prolong the sensor’s life, drive regularly over longer distances so the exhaust warms up thoroughly and the excess water is discharged. Short drives are the fastest way to damage a NOx sensor.

Thermal shock. This can happen if you drive into a deep puddle or a snow-drift. Near the NOx sensor the exhaust is hundreds of °C hot, and even hotter when driving aggressively or when the DME is desulphating the NOx catalytic converter. If water reaches the exhaust, the temperature drops sharply, and rapid temperature changes can also damage the NOx sensor.

Fuel, oil and mixture problems

Fuel. If an injector leaks, unburned fuel gets into the exhaust and ignites at some point. If a cylinder misfires, oxygen also gets into the exhaust. Fuel and oxygen together are a perfect combination for burning or even exploding.

Watch for these symptoms:

  • permanent vibration, typically during and after a cold start;
  • the engine shivering while driving;
  • the EML (Check engine) light coming on.

If you see any of them, fix the problem immediately. Leaking injectors and misfiring cylinders will damage the NOx sensor, and they can also damage other Lambda probes and the CO catalytic converters. The longer you postpone the repair, the more expensive it gets.

Increased oil consumption. If the engine consumes more oil, the burned oil settles in the exhaust, in the CO catalytic converters and Lambda probes, and damages them. The solution is to eliminate the cause of the oil consumption. On engines with normal mileage, the cause is a defect in the crankcase ventilation.

Other causes of an incorrect fuel mixture. If the mixture is enriched, fuel gets into the exhaust and burns there, forming soot. The soot “sticks” to the NOx sensor’s probe, so it can no longer sense the content of the exhaust gases. I suggest having N43/N53 series engines checked regularly by a knowledgeable specialist, or running Online diagnostics with Bimmerprofs, to make sure all engine systems work as they should. An incorrect mixture also damages the CO catalytic converters, so repair any engine problem as soon as possible.

Mechanical damage and additives

Mechanical damage. If a piece of rock or any other foreign body hits the probe or the exhaust, it can damage the NOx sensor. The sensor’s measuring element is a very thin, fragile ceramic plate, and a blow to the sensor body is fatal for it. Such damage is very hard to avoid. The only advice is to drive very carefully on gravel roads and over larger (higher) obstacles.

Additives that “improve” engine performance. This covers anything intended to clean cylinders and valves, improve compression, reduce exhaust emissions, increase power and so on. These additives can permanently damage Lambda probes and CO catalytic converters, and very often do. They can also cause injectors to leak. The solution is not to use any such “improving” additives under any circumstances.

BEYOND THE FAULT CODE

A clearer picture.
A better next step.

Get in touch
Enlarged technical image
Open original image